- 42 - Ultra-Low Temperature Freezer INSTRUCTION MANUAL MDF-U7486SMDF-U7486SC MDF-U5486SMDF-U5486SC MDF-U74
- 51 -9 FREEZER COMPONENTS 1. Outer door: To open the outer door, grip the handle. On closing, lock the outer door latch completely. 2. Inner
- 52 - 10 FREEZER COMPONENTS Control panel 1. Digital temperature indicator: This indicator shows the present chamber temperature or
- 53 -11 INSTALLATION SITE To operate this unit properly and to obtain maximum performance, install the unit in a location with the following cond
- 54 - 12 INSTALLATION 1. Remove the packaging materials and tapes Remove all transportation packaging materials and tapes. Open the doors and v
- 55 -13 START-UP OF UNIT Follow the procedures for the initial and consequent operations of the unit. 1. Turn off the switch of the back-up syst
- 56 - 14 CHAMBER TEMPERATURE SETTING Table 1 shows the basic procedure for setting the chamber temperature. Perform key operations in the seque
- 57 -15 ALARM TEMPERATURE SETTING This unit is provided with the high and low temperature alarm and the temperature at which the alarm is activat
- 58 - 16 SETTING OF ALARM RESUME TIME The alarm buzzer is silenced by pressing alarm buzzer stop key (BUZZER) on the control panel during alarm
- 59 -17 REMOTE ALARM TERMINAL The terminal of the remote alarm is installed at the lower left side of the unit. The alarm is outputted from th
- 60 - 18 SETTING OF COMPRESSOR DELAY TIME The delay time of high and low stage side compressor can be changed to reduce the load on the power l
- 43 -1 CONTENTS INTRODUCTION P. 2 PRECAUTIONS FOR SAFE OPERATION P. 3 ENVIRONMENTAL CONDITIONS P. 7 FREEZER COMPONENTS P. 8
- 61 -19 ALARMS & SAFETY FUNCTIONS This unit has the alarms and safety functions shown in Table 7, and also self diagnostic functions. Table
- 62 - 20 ROUTINE MAINTENANCE WARNING Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in order to pre
- 63 -21 ROUTINE MAINTENANCE Defrosting of inside wall The frost is built at the upper portion of the chamber and inner door. The excessiv
- 64 - 22 ROUTINE MAINTENANCE Cleaning of air intake port The cap of the left side is turned counterclockwise (Counterclockwise direction), an
- 65 -23 TROUBLE SHOOTING If the unit malfunctions, check out the following before calling for service. Malfunction Check/Remedy The chamber is n
- 66 - 24 DISPOSAL OF UNIT WARNING If the unit is to be stored unused in an unsupervised area for an extended period ensure that children do not ha
- 67 -25 DISPOSAL OF BATTERY Location of a nickel-metal-hydride battery This unit is provided a nickel-metal-hydride battery for the power failure
- 68 - 26 BACK-UP SYSTEM (OPTION) WARNING As with any equipment that uses CO2 gas, there is a likelihood of oxygen depletion in the vicinity of th
- 69 -27 TEMPERATURE RECORDER (OPTION) Installation of MTR-85H/MTR-G85 Contact Sanyo sales representative or agent for the attachment of an aut
- 70 - 28 INVENTORY RACK (OPTION) The optional inventory rack is useful to store the precious materials in the chamber effectively. When the rack
- 44 - 2 INTRODUCTION Read this manual carefully before using the appliance and follow the instructions for safety operation. Sanyo never guar
- 71 -29 SPECIFICATIONS Name Ultra-Low Temperature Freezer Model MDF-U5486S MDF-U5486SC External dimensions W890 x D870 x H1990 (mm) Internal di
- 72 - 30 SPECIFICATIONS Name Ultra-Low Temperature Freezer Model MDF-U7486S MDF-U7486SC External dimensions W1130 x D875 x H1990 (mm) Internal d
- 73 -31 PERFORMANCE Model MDF-U5486S MDF-U5486SC (for U.S.A. only) MDF-U7486S MDF-U7486SC (for U.S.A. only) Cooling performance -86oC at the ce
- 74 - 32 CAUTION Please fill in this form before servicing. Hand over this form to the service engineer to keep for his and your safety. Safet
SANYO Electric Co., LtdPrinted in Japan
- 45 -3 PRECAUTIONS FOR SAFE OPERATION It is imperative that the user complies with this manual as it contains important safety advice. Items and
- 46 - 4 PRECAUTIONS FOR SAFE OPERATION Do not use the unit outdoors. Current leakage or electric shock may result if the unit is exposed to
- 47 -5 PRECAUTIONS FOR SAFE OPERATION Ensure you do not inhale or consume medication or aerosols from around the unit at the time of maintena
- 48 - 6 PRECAUTIONS FOR SAFE OPERATION Use a dedicated power source (a dedicated circuit with a breaker) as indicated on the rating label atta
- 49 -7 ENVIRONMENTAL CONDITIONS This equipment is designed to be safe at least under the following conditions (based on the IEC 61010-1): Indo
- 50 - 8 FREEZER COMPONENTS Rear sidePower cord 12 12569 (inside) 1013415 13 (inside) 811 73171816
Comments to this Manuals