Sanyo LNS-S04 Installation Manual download pdf

LCD PROJECTOR LENS

MODEL NO. LNS-S04/LNS-M02

LENS REPLACEMENT

AND INSTALLATION PROCEDURES

NOTES ON REPLACEMENT AND INSTALLATION

The procedures and the needed pars for lens installation depend on the type of

cabinet. Before installing or replacing the lens, make sure the type of cabinet and be

sure to refer to the Installations corresponding with your projector.

When installing or replacing the lens, make sure the Lens Model No. matches with

your projector. Refer to the catalog, or contact your sales dealer for the proper Lens

Model No.

TYPE OF THE CABINET AND INSTALLATION PROCEDURES

Refer to the Installation procedure corresponding to your projector and install the lens

correctly. (See the chart below.)

1AA6P1P5925-- (IFTT)

※ For use the other models (other than above cabinet), contact your sales dealer.

Printed in Japan

1 2 3 4 5 6

LCD PROJECTOR LENSMODEL NO. LNS-S04/LNS-M02LENS REPLACEMENT AND INSTALLATION PROCEDURESNOTES ON REPLACEMENT AND INSTALLATIONThe procedures and the

Some parts are not used for installation or replacement. Keep these parts for later use.Note : Figures in this manual may be differ from the actual p

Page 3

-2- Turn the Lens Mount Cover counter-clockwise and take it off by pulling forward. (See Fig. 1)Fig. 1Lens Mount Cover AFig. 2BABRemove 2 Screw

-3-Grasp (release lock) the Lens Lock Lever and turn it fully upward. (See Fig. 7)Install the Lens into the projector. Grasp the Lens L

-4- To ensure that the lens is securely fixed to the projector when mounting, be sure to attach the Safety Clamp (supplyed with the projecto

-5-Fig. 12Fit the raised dot of the Lens Mount Cover to the leftmost edge of the Seal on the projector, and then turn the Lens Mount Cove

No comments

Sanyo LNS-S04 Installation Manual