Sanyo CCA-BC200 User Manual

INSTRUCTION MANUAL CCA-BC200 Rear View Back up Camera System SANYO’S HELP-LINE Call the toll-free number below if

−9− CONNECTION • Installation and wiring require technical expertise and experience. To ensure proper installation and safety,

−10− BEFORE INSTALLATION Rear View Back up Camera System Installation Cautions • Bundle cables with tape or string so that they do not obstruct dri

−11− Determination of Camera Installation Position (example) • Temporarily adhering the camera with the tape, locate a suitable installation positi

−12− INSTALLATION Installing system on rear spoiler 1. Clean the location where the camera is to be installed. Wipe off oil, wax, moisture, dirt an

−13− 4. Adjust the camera angle so that the extreme rear end of the vehicle (bumper, rear window, and liftgate.) is displayed at the bottom of the m

−14− 7. Install the control switch in a position where it is easy to operate. Peel off the paper backing on the back of the control switch and attac

−15− CABLE ROUTING The following is an example when installing the camera on the rear spoiler. 1. Route the camera cable along the top

−16− 3. Route the camera cable to the ECU box positioned inside the vehicle and clamp it using the cable clamps. Insert the cable into the slit pro

−17− GUIDE LINE ADJUSTMENT AFTER REAR VIEW CAMERA INSTALLATION The guide lines on the screen need to be aligned with the image taken from the rear

−18− Alignment Mode Turn the ignition switch to the ACC ON position while depressing the control switch. • Press and hold the control switch until

-1-

−19− 1. View-from-top angle alignment (flashing white rectangle) 1-1. Each time the control switch is pressed, the angle increases. Continuously p

−20− 3. View-from-top height alignment (flashing violet rectangle) 3-1. Press the control switch to change to a higher or lower view-from-top.

−21− 5. Right guide line alignment (flashing green rectangle) 5-1. Each time the control switch is pressed, the right guide line moves towards the

−22− 7. 1.5 ft. guide line alignment (flashing blue rectangle) 7-1. Each time the control switch is pressed, the 1.5 ft. guide line moves farthe

−23− REAR VIEW BACK UP CAMERA DISPLAY AND SWITCHING DISPLAY MODES Preparation prior to use Make sure the ignition switch is in the ON or ACC positio

−2− CONTENTS SAFETY PRECAUTIONS···································································································· 2 SPECIFICATION

−3− • When installing this Rear View Back up Camera System to a vehicle equipped with air bags (The name differs depending on the manufacturer, such

−4− • Route wiring properly according to the instructions. An incorrect connection might cause a fire or accident. • Be careful and prevent the wir

−5− BEFORE USING THE REAR VIEW BACK UP CAMERA SYSTEM Regarding methods of use • The Rear View Back up Camera System is a devise designed only to

−6− ACCESSORIES AND HARDWARE Make sure all the following parts are included in the Rear View Back up Camera System kit. 1 R

−7− REAR VIEW BACK UP CAMERA SYSTEM OUTLINE Display mode Including the standard rear view image captured by the camera, a digitally corrected re

−8− CAUTIONS FOR CONNECTION • Before connecting, disconnect the negative battery terminal. Connect the negative battery terminal