Sanyo DC-DA1465M User Manual download pdf (Page 5)

Inserting batteries

Note:

Always remove battery if the remote control is not to be used for a month

or more. Battery within the unit may leak and cause damage.

Two R03/AAA batteries (not supplied)

Remote control range

The buttons on the remote control perform similar functions to similarly

marked buttons on the front panel.

Within approx. 7 meters

Remote sensor

ADJUSTING THE CLOCK

When the unit is ﬁ rst connected to the AC power line, the display blinks

“00:00” dimly.

Example: To set “6:30”.

First, press the

/ON button to turn the power on.

1. Press the PROGRAM/CLOCK button for at least 2 seconds. “-- --:--

--”(when the first time setting) or the current time appears on the

display.

2. Press the PROGRAM/CLOCK button again. After “SET CLOCK”

appears on the display, the time system appears. Press the

button to select “24HR”.

3. Press the PROGRAM/CLOCK button. The hours display blinks.

4. Press the

button to set the “hours”.

5. Press the PROGRAM/CLOCK button. The minutes display blinks.

6. Press the

button to set the “minutes”.

7. Press the PROGRAM/CLOCK button to complete the setting, the

original function returns.

- The time can be set accurately by pressing the PROGRAM/

CLOCK button when a time signal is heard.

- To display the clock during operations, press the PROGRAM/

CLOCK button at least 2 seconds. After a few seconds, the original

display returns.

- If a power failure occurs or the mains lead is disconnected, the clock

display blinks. Reset the time again.

1465AUEnglish.indd 41465AUEnglish.indd 4 2008-7-28 10:00:182008-7-28 10:00:18

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Sanyo DC-DA1465M User Manual Page 5