Sanyo VPC-E1090 User Manual download pdf (Page 29)

Camera Setup 17

Charging the Battery

English

Charging the Battery

1. Insert the battery into the camera and connect the DC

power supply cable with the power adapter as shown in

the picture.

2. Connect the power adapter to a live household outlet to

start charging. The power LED will blink during the

charging process.

3. Disconnect the DC power supply cable when the charging is

done. When the charging is done, Power LED turns off.

Charging the Battery with USB power

1. Turn the power off and connect the USB cable with the camera and the computer.

2. The power LED will blink during the charging process.

3. The power LED will turn off automatically when the charging is done.

4. Disconnect the USB cable.

Note:

1. The room temperature suitable for charging the camera is 6°C ~ 36°C. Power LED blinks

during the charge and turns off automatically after the charge.

2. The battery does not charge when room temperature exceeds 36°C or falls below 6°C.

Power LED will blink faster. The battery does not charge again automatically even when the

temperature comes back to 6°C ~ 36°C, once the charge stops by higher or lower

temperature.

3. To recharge the battery, plug out the DC power supply cable or USB cable and plug in again

by increasing or decreasing the temperature of the battery and the camera when room

temperature is not suitable for charging.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 69 70

No comments

Sanyo VPC-E1090 User Manual Page 29