VSE-2300 &VSE-2400 SERIESINSTRUCTION MANUALCylindricalEnvironmental Camera HousingsAbout this manualBefore installing and using this unit, please
10See DetailCover RibTop of BaseSealFigure 10: Reinstalling the Cover3. As the cover nears the rear cap, make sure the captivescrews in the back are n
11THIS WARRANTY IS VALID ONLY ON SANYO PRODUCTS PURCHASED OR RENTED IN THE UNITED STATES OF AMERICA,EXCLUDING ALL U. S. TERRITORIES AND PROTECTORATES.
Sanyo Fisher CompanySecurity Video Division21605 Plummer StreetChatsworth, CA 91311Tel: (818) 998-7322 Fax: (818) 717-2716 Technical Support: (888)
2IMPORTANT SAFEGUARDS1. Read Instructions - All the safety and operating instructionsshould be read before the unit is operated.2. Retain Instructions
SAFETY PRECAUTIONSThis label may appear on the bottom of the unit due to spacelimitations.The lightning flash with an arrowhead symbol withinan equila
CONTENTS1 UNPACKING . . . . . . . . . . . . . . . . . . . . . . . . . . . . .42SERVICE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5Model NumberPreinstalled Heater orHeater/Blower1Voltage/Power (V/W)VSE-2300 ---VSE-2300H Heater 24/23VSE-2300HB Heater/Blower 24/25VSE-2400 ---VSE-24
6.3 Housing Mounting1. Use the two 1/4-20 x 0.50-inch screws and 1/4-inch springwashers provided in the hardware kit to mount thehousing to a mount or
6.5 Camera/Lens Installation1. Loosen the two screws holding the camera bracket to thebase. It is not necessary to remove them completely. SeeFigure 3
3. The terminal block provided on /x0 units accepts wireranging from 20 to 14 AWG or 1.5 mm2. The terminalblock provided on /x1 units accepts wire ran
6.8 Lens WiringWARNING: Only use the cables specifiedunder "INSTALLATION, Cable Requirements"for wiring of the lens.1. Install the last 1/2-
Comments to this Manuals