Sanyo DP42647 User Manual download pdf (Page 14)

Install batteries in remote control (2AA, not included).

Connect Signal to the DTV’s Integrated Analog / Digital

75 ohm Antenna Input terminal.

GETTING STARTED (REQUIRED INITIAL SETUP)

PRECAUTIONS

To ensure safe operation, please observe the following

precautions:

Replace both batteries at the same time. Do not use a new

battery with a used battery.

Risk of explosion, if battery is replaced by an incorrect

type.

Do not expose the Remote Control Unit to moisture or

heat.

RF ANTENNA

CABLE

CABLE BOX OR SATELLITE BOX

ANALOG / DIGITAL

ANTENNA IN

THE TUNER IN THIS DTV CAN RECEIVE

1. Digital and / or Analog Off-Air Signals from an RF

antenna.

2. Analog or ClearQAM cable channels.

Note:You must search for ClearQAM channels using

the “Digital Cable Search” menu option.

3. The output from a VCR or cable box.

Digital signals from a Set-top (STB) Box should be

received through the Component jacks.

This DTV can receive ANY unscrambled RF signal

being broadcast.

(CONTINUED ON NEXT PAGE.)

Match the “+” and “–”

signs on the batteries with

marks inside the remote

control.

DTV RIGHT SIDE (VIEWED FROM BACK)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

No comments

Sanyo DP42647 User Manual Page 14