Sanyo PLC-HF10000L Owner's Manual download pdf (Page 11)

Part Names and Functions

Terminals and Connectors

r R/C JACK

When using the wired remote control, connect the

wired remote control to this jack with a remote

control cable (not supplied).

e USB CONNECTOR (series B)

USB connector is to used to service the projector.

y S-VIDEO JACK

Connects the S-VIDEO output signal from video

equipment to this jack (p.21).

SERIAL PORT IN TERMINAL

If you control the projector from a computer, you

must connect a cable (not supplied) from your

computer to this RS-232C terminal.

SERIAL PORT OUT TERMINAL

This terminal outputs signal from SERIAL PORT IN.

More than two projectors can be controlled with

one computer by connecting SERIAL PORT IN of

another projector to this RS-232C terminal.

u 5 BNC JACK

Connects the component or composite video

output signal from video equipment to VIDEO/Y,

Pb/Cb, and Pr/Cr jacks or connect the computer

output signal (5 BNC Type [Green, Blue, Red,

Horiz. Sync, and Vert. Sync.]) to G, B, R, H/HV, and

V jacks (pp.20–21).

q w

DIGITAL (DVI-D) TERMINAL

Connects computer output (Digital/DVI-D type) to

this terminal (p.20).

HD (HDCP Compatible) signal can be also

connected (p.21).

ANALOG TERMINAL

Connects the computer (or RGB scart) output

signal to this terminal (pp.20–21).

LAN PORT

Connecting the Ethernet cable See the owner’s

manual of “Network Set-up and Operation” for

details.

o HDMI

TERMINAL

Connects the HDMI output signal from video

equipment to this terminal. (pp.20–21)

o i!0

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 98 99

Comments to this Manuals

No comments

Sanyo PLC-HF10000L Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLC-HF10000L