Sanyo PLC-XP100L User Manual download pdf (Page 78)

Serial Control Interface

Appendix Appendix

This projector provides a function to control and monitor the projector's operations by using the RS-232C serial

port.

Connect a RS-232C serial cross cable to CONTROL

PORT on the projector and serial port on the PC.

(See p.20)

Launch a communication software provided with PC

and setup the communication condition as follows:

Baud rate : 9600 / 19200 bps

Parity check : none

Stop bit : 1

Flow control : none

Data bit : 8

Type the command for controlling the projector and

then enter the "Enter" key.

Example

When you want to change the input to INPUT 2, Type

'C' '0' '6' 'Enter'.

✔Note:

• Enter with ASCII 64-byte capital characters and one-

byte characters.

✔Note:

• The default of the baud rate is set to 19200 bps. If an

error occurs in the communication, change the serial

port and the communication speed (baud rate).

Operation

1 2 ... 73 74 75 76 77 78 79 80 81

No comments

Sanyo PLC-XP100L User Manual Page 78