Sanyo PLC-XU75 Owner's Manual download pdf (Page 18)

Basic Operation

Connect the projector’s AC power cord into an AC

outlet. The POWER indicator becomes red.

Press the POWER ON/STAND-BY button on the

top control or on the remote control. The POWER

indicator becomes green and the cooling fans start

to operate. The preparation display appears on the

screen and the count down starts.

After the countdown, the input source that was

selected the last time and the Lamp mode status

icon (see page 48) appears on the screen.

If the projector is locked with a PIN code, PIN code

Input Dialog Box appears. Enter the PIN code as

instructed below.

Complete peripheral connections (with a computer,

VCR, etc.) before turning on the projector.

Turning On the Projector

To Enter a PIN code

Select a number by pressing the Point ed buttons,

and then press the Point 8 button to fix the number

and move the pointer. The number changes to "✳". If

you fixed an incorrect number, move the pointer to the

number you want to correct by pressing the Point 7

button, and then select the correct number by pressing

the Point ed buttons.

Repeat this step to complete entering a four-digit

number.

"1234" is set as the initial PIN code at the factory.

After entering the four-digit number, move the pointer

to "Set" by pressing the Point 8 button. Press the

SELECT button so that you can start to operate the

projector.

If you entered an incorrect PIN code, "PIN code" and

the number (✳✳✳✳) turns red. Enter the correct PIN

code all over again.

What is PIN code?

PIN (Personal Identification Number) code that allows

the person who knows it to operate the projector.

Setting a PIN code prevents unauthorized use of the

projector.

A PIN code consists of a four-digit number. Refer to the

PIN code lock function in the Setting on pages 49 and

50 for locking operation of the projector with your PIN

code.

CAUTION ON HANDLING PIN CODE

If you forget your PIN code, the projector can no longer

be started. Set a new PIN code with special care,

write it down in column on page 66 of this manual, and

keep it at hand. Should the PIN code be missing or

forgotten, consult your dealer or service center.

The preparation display disappears after 30

seconds.

(See page 48 for Lamp mode.)

Selected Input Source and Lamp Mode

Lamp mode

After the OK icon

disappears, you can

operate the projector.

PIN Code Input Dialog Box

✔ Note:

• When the Input Search function is set

on On1 or On2, the input signal will

be searched automatically (p.46)

• When the Logo select function is off,

the logo is not shown on the screen.

(p.43)

• When the "Countdown off" or "Off"

is selected in the Display function,

the countdown is not shown on the

screen. (p.43)

• During the countdown period, all

operations are invalid.

• If the correct PIN code number is

not input for three minutes after the

PIN code dialog box appeared, the

projector is turned off automatically.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 66 67

Comments to this Manuals

No comments

Sanyo PLC-XU75 Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLC-XU75