Sanyo PLC-XW50 User Manual download pdf (Page 55)

Maintenance and Cleaning

Be sure to reset the Lamp replacement counter after the lamp is replaced. When the Lamp

replacement counter is reset, the LAMP REPLACE indicator stops lighting.

Turn the projector on, press the MENU button to

display the On-Screen Menu. Press the Point 7

8 buttons to move the red framed pointer to the

Setting Menu icon.

Press the Point ed buttons to move the red

framed pointer to the Lamp counter function and

then press the SELECT button. A dialog box

appears showing the total accumulated lamp hours

and reset option. If you select "Reset", a "Lamp

replacement counter Reset?" message appears.

Select [Yes] to continue.

Another confirmation dialog box appears, select

[Yes] to reset the Lamp replacement counter.

Lamp Replacement Counter

✔ Note:

Do not reset the Lamp replacement counter

without implementing lamp replacement. Be sure

to reset the Lamp replacement counter only after

replacing the lamp.

Select [Yes],

then another

confirmation

box appears.

Select [Yes] again

to reset the lamp

counter.

To reset the lamp counter,

move the pointer to

Reset and then press the

SELECT button. “Lamp

replacement counter

Reset?” dialog box is

displayed.

This projector uses a high-pressure lamp which must be handled carefully and properly.

Improper handling may result in accidents, injury, or create a fire hazard.

● Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee

of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time than

other similar lamps.

● If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE indicator lights up,

replace the lamp with a new one IMMEDIATELY after the projector has cooled down. (Follow carefully the

instructions in the Lamp Replacement section of this manual.) Continuous use of the lamp with the LAMP

REPLACE indicator lighted may increase the risk of lamp explosion.

● A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime

draws to an end. Risk of explosion may differ according to the environment or conditions in which the

projector and lamp are being used.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.

If a lamp explodes, disconnect the projector's AC plug from the AC outlet immediately. Contact an authorized

service station for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure

that there are no broken shards or pieces of glass around the projector or coming out from the cooling air

circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of

the projector except those who are authorized trained technicians and who are familiar with projector service.

Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do

so, may result in an accident or injury caused by pieces of broken glass.

LAMP HANDLING PRECAUTIONS

Maintenance & Cleaning

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 65 66

Comments to this Manuals

No comments

Sanyo PLC-XW50 User Manual Page 55

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLC-XW50