MDF-U32VUltra-Low Temperature FreezerINSTRUCTION MANUAL
8 FREEZER COMPONENTS 8 1 6 2 4 1215(inside)145 3 11 1718 16 5(inside) 1097 13
9 FREEZER COMPONENTS 1. Outer door: To open the door, grip the handle. On closing, lock the door latch completely. 2. Handle: Always gr
10 FREEZER COMPONENTS Control panel and keypad 1. Buzzer stop key (BUZZER): To silence the audible alarm under alarm condition,
11 INSTALLATION Installation site To operate this unit properly and to obtain maximum performance, install the unit in a location with the fo
12 INSTALLATION Installation 1. Remove the packaging materials and tapes Remove all transportation packaging materials and tapes. Open the d
13 OPTIONAL COMPONENTS Temperature recorder An automatic temperature recorders is available for this freezer as the optional component. The
14 OPTIONAL COMPONENTS Back-up system WARNING As with any equipment that uses CO2 gas, there is a likelihood of oxygen depletion in the vici
15 OPTIONAL COMPONENTS Inventory rack The optional inventory rack is useful to store the precious materials in the chamber effectively. When
16 START-UP OF UNIT Follow the procedures for the initial and consequent operations of the unit. 1. Connect the power cord to the dedicated out
17 TEMPERATURE SETTING Chamber temperature Table 1 shows the basic procedure for setting the chamber temperature. Perform key operations in
Note: 1. No part of this manual may be reproduced in any form without the expressed written permission of SANYO. 2. The contents of this manual
18 TEMPERATURE SETTING Alarm temperature setting This unit is provided with the high and low temperature alarm and the temperature at which t
19 ALARMS & SAFETY FUNCTIONS This unit has the alarms and safety functions shown in Table 5, and also self diagnostic functions. Table 5.
20 SETTING OF ALARM RESUME TIME The alarm buzzer is silenced by pressing BUZZER key on the control panel during alarm condition (The remote a
21 REMOTE ALARM TERMINAL The terminal of the remote alarm is installed at the lower left side of the unit. The alarm is outputted from this ter
22 MONITOR OF FREEZER STATUS The freezer has a function to monitor the running status of the unit as shown in table 7 below. This is to notice
23 CHANGE OF COMPRESSOR DELAY TIME The delay time of high and low stage side compressor can be changed to reduce the load on the power line a
24 ROUTINE MAINTENANCE WARNING Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in order to prevent
25 ROUTINE MAINTENANCE Defrosting of inside wall The frost is built at the upper portion of the chamber and inner door. The excessive frost
26 TROUBLESHOOTING If the unit malfunctions, check out the following before calling for service. The chamber is not cooled at all 1. The circuit
27 RECYCLE OF RECHARGEABLE BATTERY The unit contains a rechargeable battery. The battery is recyclable. At the end of it’s useful li
1 CONTENTS PRECAUTIONS FOR SAFE OPERATION P. 2 CAUTIONS FOR USAGE P. 6 ENVIRONMENTAL CONDITIONS P. 7 FREEZER COMPONENTS P. 8 Con
28 SPECIFICATIONS Name Ultra-Low Temperature Freezer Model MDF-U32V External dimensions W670 x D875 x H1860 (mm) Internal dimensions W490 x
29 CAUTION Please fill in this form before servicing. Hand over this form to the service engineer to keep for his and your safety. Safety ch
7FB6P10134200 Recycled paper SANYO Electric Biomedical Co., Ltd.5-5, Keihan-Hondori 2-Chome Moriguchi Ci
2 PRECAUTIONS FOR SAFE OPERATION It is imperative that the user complies with this manual as it contains important safety advice. Items and proc
3 PRECAUTIONS FOR SAFE OPERATION Do not use the unit outdoors. Current leakage or electric shock may result if the unit is exposed to rain w
4 PRECAUTIONS FOR SAFE OPERATION Ensure you do not inhale or consume medication or aerosols from around the unit at the time of maintenance.
5 PRECAUTIONS FOR SAFE OPERATION Check the setting when starting up of operation after power failure or turning off of power switch. The s
6 CAUTIONS FOR USAGE 1. When the first start-up or start-up after no use of long period, the warning device may not operate, because its Ni-MH ba
7 ENVIRONMENTAL CONDITIONS This equipment is designed to be safe at least under the following conditions (based on the IEC-1010-1): 1. Indoor us
Comments to this Manuals