Sanyo DMP-692 User Manual download pdf (Page 8)

BATTERY BACK-UP SYSTEM

This system includes a battery back-up circuit that will maintain the time and alarm settings,

and the preset tuner memories, in the event of a temporary power interruption. The battery

back-up system requires one 3-Volt lithium button cell (Type CR2032 or equivalent). If the

back-up battery is not installed, or the battery is exhausted, and the AC power supply is

interrupted, the time, alarm, and preset memory stations will be lost. It will be necessary to

reset the unit when the power is restored.

The Battery Back-Up compartment is located on the bottom cabinet.

Activating the Back-Up Battery

The CR2032 lithium battery is already installed in the battery compartment on the bottom,

pull out the small mylar insulation tab as shown in the illustration to begin using the unit for

maintain the time and alarm settings and the preset tuner memories.

Replacing The Back Up Battery

When it’s time to replace the battery the Low Battery lcon ( ) will be shown in the lower left

corner of the display. Insert a fresh CR2032 battery following the below procedure, however

leave the unit connected to the AC adaptor while replacing the battery to avoid losing all of your

settings.

1. Turn the unit upside down on a soft surface such as a cloth or towel to avoid scratching

the top cabinet surface.

Open the battery compartment cover and remove the old battery as shown in the illustration.

3. Insert a fresh, well-known brand of CR2032 lithium battery into the compartment with the

“+” side facing up. Close the battery compartment cover.

4. Turn the unit right side up.

Battery

Compartment

Remove the battery

slide the battery to right side as

below illustration and then release.

Insert battery

PULL

small mylar insulation tab

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 34 35

No comments

Sanyo DMP-692 User Manual Page 8