Sanyo PLC-SW30 User Manual download pdf (Page 19)

Connect the projector's AC Power Cord into an AC outlet. The

POWER indicator flashes in a moment and then turns red.

Press POWER ON-OFF button on the top control or the remote

control. The POWER Indicator turns green, and the cooling fans

start to operate. The starting display appears on the screen and

the count-down starts.

Tu r ning Off the Projector

Press the POWER ON-OFF button on the top control or the

remote control, and the message " Power off? " appears on the

screen.

Press the POWER ON-OFF button again to turn off the

projector. The POWER indicator starts to flash red and continues

while the cooling fans are operating. (for approx. 90 seconds)

TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURN

PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE

TURNING IT OFF.

DO NOT DISCONNECT THE AC POWER CORD WHILE

COOLING FANS ARE RUNNING OR BEFORE POWER

INDICATOR LIGHTS RED. OTHERWISE IT WILL RESULT IN

SHORTENING LAMP LIFE.

Tu r ning On the Projector

Complete peripheral connections (with a computer, VCR, etc.)

before turning on the projector.

When the projector is cooled down enough to be turned on

again, the Power indicator turns red again. Then you can

disconnect the AC power cord.

– The starting display disappears after 30 seconds.

– The starting display can be changed. (

☞

" Capture " P36 )

Power off?

Message disappears after 4 seconds.

Basic Operation

After the count-down, the input source that was selected last

and the Lamp mode status appear on the screen.

Note :

– When the Power Management function is ON, the projector detects signal

interruption and automatically turns off the projection lamp. (

☞ P 37 )

– The projector cannot be turned on during the cooling period with the

POWER indicator flashing red. You can turn it on again after the POWER

indicator lights red.

– Do not use the projector for more than 24 hours continuously. Turn off the

projector at least once in 24 hours and give it a rest. Continuous use may

result in shortening the lamp lifetime.

– This projector detects internal temperature and automatically controls the

running speed of the cooling fans.

– If the WARNING indicator flashes or lights red, see “Warning Indicator” on

page 42

(

☞

" Lamp mode " P37 )

Selected Input Source and Lamp Mode

Lamp mode

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Comments to this Manuals

No comments

Sanyo PLC-SW30 User Manual Page 19

Comments to this Manuals

Related products and manuals for Projectors Sanyo PLC-SW30