Sanyo CE28DFN2-B User Manual download pdf (Page 3)

Connect your aerial cable socket to the back of the TV set. Fit the aerial

cable as shown below or as shown opposite when AV equipment is con-

nected.

Connect the power cord of the TV set to a wall outlet.

✐ The TV set is prepared for a mains voltage AC220~240V, 50Hz.

When the TV set is not to be used for an extended period of time,

it is advisable to disconnect the power cord from the power outlet.

✐ For all aerial problems please consult your local dealer.

● Connecting DVD / VCR player or Satellite receiver.

We recommend that you connect all other equipment before Plug and

Play. The following examples are our recommended standard

connection. For further information please consult your local dealer.

Please refer to individual Instruction Manuals for each piece of equip-

ment for their connection suggestions.

Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the

batteries match the "+" and "-" marks inside the unit into the remote

control handset.

INST

ALLA

TION

Step : 1 Connections ( Essential)

ANT.75Ω

AV1

AV2

AC Mains Outlet

WARNING! High voltages are used in the operation of

this set. Refer service to qualified service personnel.

ANT.75‰

VCR

OUT

Satellite

VCR

DVD

Option if no DVD

For Satellite

only

DISH

TV rear panel

AV2

AV1

Important:

This equipment is fitted with an approved non rewireable UK mains

plug. To change a fuse in this type of plug proceed as follows:

1. Remove the fuse cover and fuse.

2. Fit a new fuse which should be a BS1362 5Amp A.S.T.A. or BSI

approved type.

3. Ensure that the fuse cover is correctly refitted.

If the fuse cover is lost or damaged the plug must NOT be used but

replaced with a serviceable plug.

If the fitted plug is not suitable for your socket outlets, it should be

cut off and an appropriate plug fitted in its place. If the mains plug

contains a fuse, this should have a rating of 5 Amp, ensure the fuse

cover is correctly fitted. If a plug without a fuse is used, the fuse at

the distribution board should not be greater than 5 Amp.

Note: The severed plug must be destroyed to avoid a possible

shock hazard should it be inserted into a 13Amp socket elsewhere.

The wires in this mains lead are coloured in accordance with the

following code:

Blue -------> Neutral

Brown ----> Live

1. The Blue wire must be connected to the terminal whichis marked

with the letter “N” or coloured BLACK.

2. The Brown wire must be connected to the terminal with the letter

“L” or coloured RED.

3. Do not connect either wire to the earth terminal in the symbol or

coloured GREEN or GREEN and YELLOW.

Before replacing the plug cover, make certain that the cord grip is

clamped over the sheath of the lead - not simply over the wires.

Please make sure that you have read the End-User section on page 2

before you activate Plug and Play.

Step : 2 Remote control battery installation

1 2 3 4 5 6 7 8 ... 19 20

Comments to this Manuals

No comments

Sanyo CE28DFN2-B User Manual Page 3

Comments to this Manuals