Sanyo STB0810C1 User Manual download pdf (Page 6)

Operation: 1. Set the mode selector for fan, cooling or heating operation.

2. Set the thermostat to the desired position. (Refer to the setting

temperature guide above.)

Set the operation selector switch.

NOTE

The above temperatures are provided for reference only, and may differ

from the actual temperature of the room.

How to stop the air

conditioner:

To stop the air conditioner, set the mode selector to OFF position.

How to restart the air

conditioner:

To restart the air conditioner, set the mode selector to desired position.

CAUTION

If the unit is turned off during cooling and heating, DO NOT restart it

immediately, as this can damage it. Wait at least three minutes before

starting

Freezing Up:

If you notice that your air conditioner is not cooling as it should, it may

be that ice has formed on the cooling coils. The ice blocks air flow and

stops the unit from cooling the room. This “freezing up” is a temporary

condition that most often occurs at night when the Thermostat is set on

the coldest setting and the Selector is set on LOW COOL.

To correct the condition set the Selector at (H or L) FAN or HIGH COOL

with the Thermostat with turning the thermostat knob to the opposite

direction from ”COOLER”.

it again.

WARMER

(88°F) (55°F)(55°F)

COOLERCOOLER

THERMOSTAT

(setting temperature guide)

6 OI-602-06EG

oi602000

Cooling Only Model Cool/Heat Model

Control Panel and Operation

Functions (continued)

1 2 3 4 5 6 7 8 9 10 11

No comments

Sanyo STB0810C1 User Manual Page 6