Sanyo VCC-4594 User Manual download pdf (Page 15)

SETTINGS

White balance adjustment

Normally the switch 5 (WB) is set to the down (ATW: auto white

balance) position and the white balance is adjusted automatically. If a

manual white balance adjustment is necessary, follow the steps below.

Set the switch 5 (WB) to the up (M: manual) position, then adjust the

colour.

• Turn RED (VR302) to set the red ratio and/or BLUE (VR303) to set

the blue ratio.

Synchronization settings

The default setting is internal synchronization (INT). You can change

the power supply synchronization by moving switch 6 to the up (LL)

position. Refer to “Line phase adjustment” for details.

Line phase adjustment

When using a camera switcher to connect 2 cameras or more to one

monitor, there may be a vertical roll of the images when switched. In

such a case, set as described below.

1 Set the switch 6 (SYNC) to the up (LL) position.

2 Switch the display on the monitor from camera 1 to camera 2.

Adjust the LINE PHASE volume on camera 2 until the vertical roll

of the image stops.

If more than two cameras are used, please repeat this procedure

for all the cameras.

CAUTION:

If the vertical roll cannot be corrected by setting the LINE PHASE

volume on camera 2, try setting the LINE PHASE volume on camera

1. If it still cannot be corrected, please check that the polarity of the

power cords of all connected devices is correct.

VR302VR303

BLUE

L53Z4/US GB 2001, 4, 2

14 English

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

Sanyo VCC-4594 User Manual Page 15