Sanyo ECD-T1580DV User Manual download pdf (Page 20)

20

OPERATION

Remote Sensor

There is a remote sensor on the front

panel. On the monitor, there is another

remote sensor to receive remote control

signal. You can point the remote control

handset to the remote sensor on the front

panel (when the monitor doesn't stretch

out) or the remote sensor on the monitor

panel (when the monitor stretches out)

and press function keys on the remote

control to control the DVD unit.

The unit is also connected to an external

remote receiver (See the electrical

connection diagram above), and the

function is the same with the remote

sensor on the front panel or on the

monitor panel.

Notes:

The external remote receiver is placed

near the monitor for the best to

reception of the remote signal..

If the angle of the monitor from vertical

exceeds (Especially the distance

exceeds 3m.), controlling the DVD unit

through the remote sensor on the front

panel may not be effective. You are

suggested to use the external remote

receiver.

.

6.5 Inch TFT Display

When the monitor stretches out, the 6.5

inch color TFT display can show the

current state of the unit.

Volume Level Adjustment

Press VOL+/- buttons on the remote

control to increase or decrease the

volume level.

Mode Selection

Press MODE button on the remote

control to select among DVD, RADIO TV,

AV and RGB mode.

Reset

Reset button is placed on the front panel

and must be activated with either a

ballpoint pen or thin metal object. The

reset button is to be activated for the

following reasons:

- Initial installation of the unit when all

wiring is completed.

- All the function buttons do not

operate.

- Error symbol on the display.

Picture mode Adjustment

Press PICT button on the monitor panel,

the picture mode will show on the

display, repeatedly press PICT button to

select among BRIGHT, CONTRAST,

COLOR, TINT (For the unit with NTSC

system) and SCREEN.

Press +/- buttons on the monitor

panel to adjust the selected item. The

corresponding value will show on the

display.

30

(For the unit with NTSC system):

PICTURE

BRIGHT 32

CONTRAST 32

COLOR 32

TINT 32

NOTE (FOR THE UNIT WITH

TEL-MUTE AND BRAKE FUNCTION):

When there is an incoming call, the

unit will be in mute state, and “TEL

MUTE” appears on the screen

display.

If you are driving the car (BRAKE

OFF), the picture will not be shown on

the screen in DVD/TV/AV mode for

safety purpose. Only the audio will be

heard.

SCREEN 16:9

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Comments to this Manuals

No comments