Sanyo FXCD-500 User Manual download pdf (Page 10)

RADIO OPERATION

I I I I I I

SELECTING RADIO MODE

Press the BND button 0 to switch from tape, CD or CD changer* mode to the radio

Each time the BND button is pressed, the selected band changes as shown below

* If a CD changer is connected

FM1 - FM11 - AM

RADIO TUNING

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Automatictuning Press the TUNE/SEEK/TRACK @ or 8 button @ for more than 1 second until it

beeps twice if the beep tones are on

When the button is released, the system will start automatic tuning and stop at the

next receivable station

Manualtuning To select higher frequency stations, press the @ button for less than 0 5 seconds

To select lower frequency stations, press the 0 button for less than 0 5 seconds

To quickly scan up or down in frequency, press

and hold the @ or 8 button Release

thebuttonwhen thedisplayapproachesthedesiredfrequency, thenpressand release

the button repeatedly until the desired frequency is displayed

In FM mode a flashing decimal point in the frequency display indicates that the system

is receiving a station 50 kHz higher than the displayed frequency

STORING PRESET STATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . .

The preset buttons @ can be used to store 6 stations in each band (FMI, FMII, and AM) for convenient access

to your favorite stations

Programmingstations

Select the desired band, then tune in the station you want to store in memory

Press and hold one of the preset buttons for more than 2 seconds

Repeat steps

and

to program additional stations

Quick tuning Select the desired band, then press one of the six preset buttons

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

No comments

Sanyo FXCD-500 User Manual Page 10