Sanyo DMP-692 User Manual download pdf (Page 25)

When connecting an iPod / iPhone to this iPod Dock, pleaase ensure

that the correct adaptor plate is used. FAILURE TO DO SO MAY

RESULT IN DAMAGE TO THE iPod / iPhone.

This iPod Dock comes with 6 removable dock adaptors. Using the correct adaptor

ensures the proper fit for your iPod / iPhone and helps to reduce the stress on the

connector when operating the iPod / iPhone.

To place a dock adaptor:

1. Refer to the compatibility table below and select the correct

dock adaptor for the iPod / iPhone.

2. Place the proper adaptor into the dock and press it into

position. The adaptor will only go in one way. The iPod

dock connector should fit through the opening in the

bottom of the adaptor.

3. Carefully align and then gently insert the iPod / iPhone into

the dock. (The iPod / iPhone must not be in a case or “SKIN”)

4. To remove/replace a dock adaptor, first remove the iPod / iPhone,

then grip the adaptor and pull gently upwards.

Charging your iPod / iPhone

Note: Please make sure you are using the correct insert for your iPod / iPhone and that it is

properly docked into this unit.

FAILURE TO DO SO MAY DAMAGE THE iPod / iPhone.

When an iPod / iPhone is inserted into the dock, it will go to standby mode then turn off. While

the iPod / iPhone is docked in the system, it will recharge (until fully charged). Please note that

older 3rd generation iPod cannot be charged by this unit.

NOTE: In order to avoid interfering with the reception, the iPod / iPhone will not be charged in

the TUNER mode(FM / AM).

iPod / iPhone OPERATION

Choosing The Correct Adaptor

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 34 35

No comments

Sanyo DMP-692 User Manual Page 25