Sanyo PLV-WF20 Owner's Manual download pdf (Page 52)

Power management

Time left before the lamp is off

Press the SELECT button at Power

management and the dialog box

appears. Use the Point 7 8

buttons to choose one of the three

options.

Press the Point d button to select

the timer, and then use the Point 7

8 buttons to set the timer

For reducing power consumption as well as maintaining

the lamp life, the Power management function turns off the

projection lamp when the projector is not used for a certain

period.

If the input signal is interrupted and no button is pressed for

more than 30 seconds, the timer display with “No signal”

appears. It starts the countdown until the lamp is turned off. The

countdown time can be set between 1 and 30 minutes.

Use the Point 7 8 buttons to set the countdown timer.

Select one of the following options:

Ready

. . . . When the lamp has been fully cooled down, the

READY indicator starts blinking. In this condition,

the projection lamp is turned on if the input

signal is reconnected or any button on the side

control or remote control is pressed .

Shutdown

. . When the lamp has been fully cooled down, the

power is turned off.

Off

. . . . . . . Power Management function is off.

Power management

✔Note:

•Factory default is “Ready: 5 min.”

• When the shutter is closed while the Power management function

is working, the Power management function is released.

Setting

RC sensor

Select a location of the infrared remote receiver of the remote

control. See “Remote Control Receivers and Operating Range”

on page 15 for details.

Both ......... Activate both the front and back receiver.

Front ........ Activate only the front receiver.

Back ......... Activate only the back receiver.

Remote control

When pressing the SELECT button at

Remote control, the Remote control

code menu appears.

The eight different remote control codes (Code 1–Code 8) are

assigned to the projector; the factory-set, initial code (Code 1)

and the other seven codes (Code 2 to Code 8).

The same code should be set on both the projector and the

remote control. For example, operating the projector in “Code

7”, the remote control code also must be switched to “Code 7”.

To change the code for the projector;

Select a remote control code in this Setting Menu.

To change the code for the remote control;

Check the Reset Switch to "Use position" in the compartment

lid on the back of the remote control.

And then during holding down the MENU button, press the

IMAGE ADJ. button corresponding times to the number of the

remote control code for the projector. (See page 16)

To reset the code for the remote control;

Slide the Reset Switch to "Reset position" in the compartment

lid on back of the remote control.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 83 84

Comments to this Manuals

No comments

Sanyo PLV-WF20 Owner's Manual Page 52

Comments to this Manuals

Related products and manuals for Film projectors Sanyo PLV-WF20