Sanyo SAP-K77RAX User Manual download pdf (Page 59)

FLAP button

Press this button either to select the setting of the airflow direction to the

auto. flap in each mode or one of the six possible positions manually or to

select the sweep function which moves the flap up and down

automatically.

: Auto flap setting: If selected in a cooling or dry operation, the flap

is set at position (7) in the following chart.

: The airflow direction can be set manually. (six positions)

: The flap moves up and down automatically.

When you press the FLAP button, the air flow direction will be changed

one by one as follows.

NOTE

SWEEP

CANCEL button

After using the TIMER ON button or TIMER OFF button to set the timer,

press this button to cancel the setting.

Back side of remote

control unit

(Cover removed)

ON/OFF operation button

This button is for turning the air conditioner on and off.

Temperature setting buttons (TEMP.)

Press the button to increase the set temperature.

Press the button to reduce the set temperature.

The temperature setting changes by 1 °C each time one of the TEMP. buttons is pressed.

The set temperature appears in the display for only 3 seconds.

Jumper wire for address switching

• The address switch changes to prevent mixing of

signals from remote control units when two air

conditioners are installed next to each other.

For more information, please contact the dealer where

you made the purchase.

OI-018-7-EG

SAP-K97GAX_EN.fm Page 7 Tuesday, January 22, 2008 6:34 PM

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 67 68

No comments

Sanyo SAP-K77RAX User Manual Page 59