Sanyo DP55360 User Manual download pdf (Page 5)

Need help? www.sanyoctv.com 1-877-864-9604

Remove the two (2) screws holding the stand

base cover and carefully dislodge.

STAND REMOVAL AND WALL

MOUNTING

(OPTIONAL)

Tools Needed: Phillips screwdriver

IMPORTANT NOTE: Place HDTV face down

on a padded or cushioned flat surface to

protect the screen and finish.

Wall mounting of the HDTV must be performed

by a skilled person.

GETTING STARTED

Install two (2) “AAA” batteries in the remote

control. (Not included)

To ensure safe operation, please observe the

following precautions:

• Replace both batteries at the same time. Do not use a

new battery with a used battery.

• There’s a risk of explosion if a battery is replaced by

an incorrect type.

• Do not expose the Remote Control unit to moisture

or heat.

• Be sure to match the “+” and “

–” signs on the

batteries with marks inside the remote control.

ANTENNA CONNECTION FOR

OFF-AIR SIGNALS OR CABLE

ANTENNA

CABLE

ANALOG / DIGITAL

ANTENNA IN

BATTERY INSTALLATION

Hook up your antenna or your cable service to

the HDTV’s ANT terminal with the use of a 75

OHM coaxial cable.

NOTE: Keep your indoor antenna at least 3 ft. away

from the television set and any other electronic

equipment.

The tuner in this HDTV can receive:

• Digital and Analog off air signals from an antenna

• Analog or ClearQAM cable channels from a direct

Cable TV connection.

Remove the four (4) screws securing the

stand base to the HDTV. CAUTION: Hold the

stand firmly as you remove the last screw.

Use the screws that are threaded into the four

(4) inserts on the back of your HDTV to secure

it to an appropriate wall mounting kit.

VESA standard interface: 400 x 400

Mounting screws measurements:

M6 (6mm) Diameter, Length—12mm (maximum)

NOTE: Wall mounting kit is not included.

1 2 3 4 5 6 7 8 9 10 ... 39 40

Comments to this Manuals

No comments

Sanyo DP55360 User Manual Page 5

Comments to this Manuals