Sanyo INVERTER SPLIT SYSTEM 8.53E+13 User Manual download pdf (Page 11)

3-8. Wiring Instructions for Inter-unit Connections

(1) Insert the inter-unit wiring (according to local codes)

into the through-the-wall PVC pipe. Run the wiring

toward the indoor side allowing approx. 10" (25 cm)

to extend from the wall face. (Fig. 24)

(2) Grasp both ends of the air intake grille, and remove

it by opening towards the front and pulling towards

you.

(3) Remove the screw on the right side cover plate and

open the cover. (Fig. 25)

(4) Route the inter-unit wiring from the back of the

indoor unit and pull it toward the front for connec-

tion. (Fig. 26a, 26b)

(5) Connect the inter-unit wiring to the corresponding

terminals on the terminal plate (Fig. 26a, 26b) while

referring to the wiring diagram.

(6) Be sure to secure the wiring with the provided

clamp.

When closing the air intake grille, press on both corners.

(Fig. 27)

Please refer to “How to replace the grille” on page 8 for

installing the air intake grille.

NOTE

Rear

panel

Wiring

Wall

10"

(25 cm)

Plastic

cover

Fig. 24

Cover

Fig. 25

Ter m inal

plate

Fig. 26a

Inter-unit

wiring

Lock nut

Earth

plate

Top of conduit

connector

Fig. 26b

Fig. 27

05-423 KHS0971-1271 12/13/05 1:23 PM Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments

Sanyo INVERTER SPLIT SYSTEM 8.53E+13 User Manual Page 11

Comments to this Manuals

Related products and manuals for Conditioners Sanyo INVERTER SPLIT SYSTEM 8.53E+13