Sanyo dc-ht210w User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
2.1.4 D.R.C. (Dynamic Range Control)
You can set this item to AUTO, ON or OFF.
2.2. DIGITAL AUDIO SETUP
2.2.1 DIGITAL OUTPUT
SPDIF/OFF: There will be no digital audio signal output. (Coaxial off)
SPDIF/RAW: The digital audio signal output will be in its raw format. Normally, this m
ode is used for DTS & Dolby Digital 5.1 signals.
SPDIF/PCM: The digital audio signal output will be in PCM format. Normally, this mode
is used for audio CD signals.
2.2.2 LPCM OUT
When DIGITAL OUTPUT is set to SPDIF/PCM, this item is available.
Select a sample rating for the digital audio output. There are two options, 48KHz and
96KHz.
NOTE: Some amplifiers don't support 96KHz sampling which will affect the coaxial
output.
2.3 CHANNEL DELAY
This item is used to set the delay time for the center, rear speakers and the subwoofer.
The delay is to compensate for the audio propagation time difference caused by the
distance difference of the speakers to the listener.
0cm
Sub
Woofer
Use the direction key [ ]/[ ] to select a speaker,
center speaker, subwoofer, left surround speaker or
right surround speaker. Then use the direction key
[ ]/[ ] to set the distance difference.
NOTE:
The unit does not support delays for when the distance
between the center or surround speakers and the
listener are longer than that between the front speakers
and the listener.
In case the channel delay settings cannot match your
speaker configuration, please set all distance
difference to 0cm. If possible, use your
receiver/amplifier to set the channel delay.
-13-
2.4 EQUALIZER
2.4.1 SOUND MODE
Select a desired sound mode in this item.
2.4.2 BASS BOOST
Set it to to boost the bass sound.
2.4.3 SUPER BASS
Set it to to get the super bass sound effect.
2.4.4 TREBLE BOOST
Set it to to boost the treble sound.
ON
ON
ON
System Setup
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments