Sanyo KH2442 User Manual download pdf (Page 178)

4. Service procedures

SM830082

IV - 22

Section

Fig. IV-4

1929_M_I

Sensor address

Sensor temperature °F

Unit No. (Indoor unit address)

(B) Check the sensor temperature readings

The air conditioner has thermo sensors which are used to control the unit.

❏ Each sensor has an address which is made up of the indoor unit address, and the

sensor address. The indoor unit address is used only when several units are hooked

up to one remote controller (group control). If there is only one unit, made up of one

indoor and one outdoor unit, then only the sensor address should be put in, as shown

in the procedure below.

Follow this procedure to display the temperature of each sensor:

a On the remote controller, press both and buttons at the same time for more than 4

seconds. (Ref. Fig. IV-4)

b The UNIT No., the address and temperature of the sensors instead of its usual informa-

tion will flash on the display.

❏ Following example shows the UNIT No. (Indoor unit address) is fixed at 01– 01.

❑ In case of group control, select the UNIT NO. (Indoor unit address) which you want to

check with button.

❏ Each time you press the , ( ) button you can select a different sensor, and the

display shows the sensor address and temperature as shown Fig. IV-4.

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 201 202

No comments

Sanyo KH2442 User Manual Page 178