Sanyo DMP-692 User Manual download pdf (Page 24)

iPod/iPhone OPERATION

This SANYO system includes two separate docking stations so that you can dock and charge

two separate iPod models, or one iPod and one iPhone model simultaneously. Since this

model is ‘Works With iPhone’ certified it is not necessary to place your iPhone in the Airplane

mode to avoid audio interference. You will be able to make and receive calls, without

interference, while the system is in operation.

Use the left side dock for any docking iPod model. Use the right side dock for any docking iPod

model or any iPhone model.

IMPORTANT NOTES:

This system is supplied with 6 different iPod adaptor/inserts intended to insure that older iPod

models fit properly in the docking area. If your iPod was supplied with a docking adaptor at the

time of purchase, that adaptor will fit properly into the docking area of this system. If you have

an older iPod model that was not supplied with a docking adaptor, please select the

appropriate adaptor from the chart below. Each adaptor is identified by the letters “A” through

“F” on the bottom of the adaptor. Select the adaptor with the letter that corresponds to your

iPod model. Position the adaptor in the docking area as shown and make sure that it ‘locks’ in

place, then place your iPod into the adaptor and make sure that the iPod connector on this

system is fully inserted into the slot on the bottom of your iPod. When properly docked your

iPod should be ‘leaning backward’ slightly on a 15 degree angle. DO NOT ATTEMPT TO

“STRAIGHTEN” YOUR IPOD. THIS COULD RESULT IN DAMAGE TO THE DOCKING

CONNECTOR OR DAMAGE TO YOUR IPOD.

The right side dock labeled iPod/iPhone has priority in this model. If you are playing an

iPod in the left side dock labeled iPod and you insert an iPhone or iPod in the right side

dock, the system will automatically switch to the iPod or iPhone in the right side dock.

When you dock an iPhone or certain newer iPod models in either dock there may be a

delay of several seconds before the system recognizes the device and the main menu is

displayed. This is because the system and the docked device must go through an

‘Authentication Process’ before the docked device can accept any commands. THIS IS

NORMAL AND NOT AN INDICATION OF ANY PROBLEM WITH YOUR SYSTEM.

Remote the iPod adaptor (E,F) illustration

Press its inside rear surface and pull it upward.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 34 35

No comments

Sanyo DMP-692 User Manual Page 24