Sanyo LNS-T02E Manual download pdf (Page 3)

LENS MOTOR LEAD

CONNECTOR “ K16B”

(D)

(D)(D)

(D)

C

LENS MOTOR

❋ Figure shown inside of the cabinet.

REMOVE THE LENS. (See figure-4)

1. Remove the connector “K16B” of the

circuit board.

2. Loosen the A, B, C wire holder and

remove the lens motor lead.

3. Remove screws D (4 screws) which

fastens the lens and remove the lens.

● IN CASE OF MODEL WITH LENS

B

ATTACHED DRIVER

Fig-5

LENS MOUNTING BRACKET

LENS MOTOR LEAD

CONNECTOR “K16B”

(D)

(D)

(D)

(D)

B

A

LENS MOTOR

Fig-4

This part wiring should

not be tightened.

C

A

INSTALL THE LENS. (See figure-4,5)

3

1. Remove protective caps (front

and back ) on the lens.

2. Mount the lens at the lens

mounting bracket with screws

(4 screws) included with the

lens. Use the driver included

with the lens to fasten the

screws . (After using, save it for

latter use.) (See figure-5)

3. Connect the lens motor lead to

the connector “K16B” of the

circuit board. (See figure-4)

4. Fasten the lens motor lead at

the A, B, C points with wire

holder.

(See figure-4)

1 2 3 4

Comments to this Manuals

No comments