Sanyo PDG-DXL2000 User Manual download pdf (Page 12)

Chapter 2 Setup Procedures

Setting procedures and contents differ depending on the LAN installation location.

When installing, consult your system administrator to set up the LAN appropriately.

Connect the LAN cable to the LAN connection terminal of the projector.

Network configuration

Set the Wired LAN network through the projector menu. Detailed network settings will be

made with browser. Refer to “3. Basic setting and operation” (p.17-30). First, complete the

settings described in this chapter before performing steps in “3. Basic setting and opera-

tion.”

Connecting to the LAN line

LINK Lamp (Green)

Light green when the

projector is connected to

the network correctly.

ACT Lamp (Orange)

Blink orange when the

projector is sending or

receiving the data.

LAN Cable

LAN Connection

Terminal

Setting Procedure

1. Select “LAN mode select” in the Network menu, and press Point 8 or SELECT button.

2. Select similar LAN environment among LAN1, LAN2 and LAN3 with the Point ed but-

tons. Then the Menu will disappear, the “Please wait...” message will appear, and switch-

ing operation will start. Switching will take a while and the projector’s LINK/ACT Lamp

will be on or blink, and after completing the operation, the “Please wait...” message will

disappear.

* Please use a shielded LAN cable.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

No comments

Sanyo PDG-DXL2000 User Manual Page 12