Sanyo PLC XP45L User Manual download pdf (Page 39)

APPENDIX

LAMP REPLACEMENT

When life of Projection Lamp of this projector draws to an end, LAMP REPLACEMENT indicator lights yellow. When a

projected image becomes dark or color of an image becomes unnatural, replacement of Projection Lamp is required.

Turn off a projector and disconnect AC plug. Allow a projector to

cool for at least 45 minutes.

Loosen 2 screws with a screwdriver and pull out Lamp Assembly

by grasping Handle.

Replace Lamp Assembly with a new one and tighten 2 screws

back. Make sure that Lamp Assembly is set properly. Replace

Lamp Cover and tighten 2 screws.

Remove 2 screws with a screwdriver and open Lamp Cover.

Connect AC Power Cord to a projector and turn it on.

Follow these steps to replace lamp assembly.

Reset Lamp Replace Counter (refer to section “Lamp Replace

Counter” below).

LAMP

ASSEMBLY

HANDLE

LAMP COVER

NOTE : Do not reset Lamp Replace Counter when Projection

Lamp is not replaced.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give following

information to dealer.

● Model No. of your projector : PLC-XP40L/PLC-XP45L

● Replacement Lamp Type No. : POA-LMP38

(Service Parts No. 610 293 5868)

LAMP REPLACE COUNTER

Be sure to reset Lamp Replace Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP

REPLACE Indicator stops lighting.

Turn projector on, press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button(s) to

move a red frame pointer to SETTING Menu icon (refer to page 35, 36).

Press POINT DOWN button to move a red frame pointer to “Lamp counter reset” and then press

SELECT button.

Message "Lamp replace counter reset?" is displayed. Move pointer to [Yes] and then press SELECT button.

Do not reset Lamp Replace Counter except after Projection Lamp is replaced.

Another confirmation dialog box appears and select [Yes] to reset Lamp Replace Counter.

CAUTION

Do not drop a lamp assembly or touch a glass

bulb! Glass can shatter and may cause injury.

CAUTION

For continued safety, replace with a lamp

assembly of same type.

Allow a projector to cool for at least 45

minutes before you open Lamp Cover. Inside

of a projector can become very hot.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

Comments to this Manuals

No comments

Sanyo PLC XP45L User Manual Page 39

Comments to this Manuals

Related products and manuals for Projectors Sanyo PLC XP45L