Sanyo PLV-HD100 User Manual download pdf (Page 22)

BASIC OPERATION

TURNING ON PROJECTOR

TURNING OFF PROJECTOR

TURNING ON / OFF PROJECTOR

Connect a projector's AC Power Cord into a wall outlet and turn

MAIN ON/OFF SWITCH to ON. LAMP indicator lights RED, and

READY indicator lights GREEN.

Press POWER ON-OFF button on Side Control or on Remote

Control Unit to ON. LAMP indicator dims, and Cooling Fans start

to operate. Preparation Display appears on a screen and count-

down starts. Signal from source appears after 30 seconds.

Current Input and Lamp status are also displayed on screen for

5 seconds. (Refer to "LAMP MANAGEMENT" on page 40.)

Press POWER ON-OFF button on Side Control or on Remote

Control Unit, and a message "Power off?" appears on a screen.

TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN

PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE

TURNING IT OFF.

Complete peripheral connections (with Computer, VCR, etc.)

before turning on projector. (Refer to "CONNECTING TO

PROJECTOR" on Pages 12~15 for connecting that equipment.)

Preparation Display disappears after

30 seconds.

Press POWER ON-OFF button again to turn off projector. LAMP

indicator lights bright and READY indicator turns off. After

approximate 90 seconds, READY indicator will light green again

and projector may be turned on by pressing POWER ON-OFF

button.

Cooling fans will operate for approximate 2 minutes after projec-

tor is turned off. To power down completely, turn MAIN ON/OFF

SWITCH to OFF and disconnect AC Power Cord.

INPUT AND LAMP STATUS

Message disappears after 4 seconds.

When WARNING TEMP. Indicator is flashing, projector cannot be turned on, refer to the section "MAINTENANCE" on page 39.

When the both WARNING TEMP. and READY Indicator flashing, refer to the section "MAINTENANCE" on page 39.

When “Power Management” function mode is Ready or Shut down, projector detects signal interruption and turns off the

Projection Lamp automatically. Refer to “Power management” on page 37.

Do not use the projector continuously for 24 hours or more. If using the projector continuously for long periods,

turn it off and leave it for one hour at least once during a 24 hour period.

If you use the projector continuously for long period, it can excessively shorten the life of the lamp.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

No comments

Sanyo PLV-HD100 User Manual Page 22