Sanyo CAS-D6325 User Manual download pdf (Page 40)

E38

SETTING UP THE ANSWERING SYSTEM

Setting the Number of Rings

The ring time setting allows you to set the number of rings the caller hears before your answering system plays the outgoing

message. You can set the ring time to answer after two, four, or six rings. If you enable the Toll Saver (TS) setting, the

answering system picks up after two rings if you have new messages, and after four rings if there are none. This way, if you

make a long distance call to check your messages, you can hang up after the third ring to avoid long distance billing charges.

On the handset, press MENU/SELECT. Select the ANSW. SETUP menu, and then the RING TIME submenu.

Move the cursor to select a ring time (TOLL SAVER, 2 TIMES, 4 TIMES, or 6 TIMES).

Press MENU/SELECT. You will hear a confirmation tone.

Setting the Day & Time

If you do not set the clock on your answering system, your messages may not have the correct time and day stamp.

On the handset, press MENU/SELECT.

Move the cursor to DAY & TIME and press MENU/SELECT.

Use and to select the day of the week, and press MENU/SELECT.

Use the number keypad (0 through 9) to enter the hour and minutes.

Use

and to select AM or PM, and press MENU/SELECT. You hear a confirmation tone.

Setting the Record Time (or Announce only)

You can choose how long callers have to record a message. Set the record time to “1 minute” or “4 minutes” to limit the

time for incoming messages. If you set the record time to “Announce only,” the answering system answers the call but

prevents callers from leaving a message.

On the handset, press MENU/SELECT. Select the ANSW. SETUP menu, and then the RECORD TIME submenu.

Move the cursor to select a record time (1 MINUTE, 4 MINUTES, or ANNOUNCE ONLY).

Press MENU/SELECT. You will hear a confirmation tone.

UC590EH.indd E38UC590EH.indd E38 8/19/2008 11:39:10 AM8/19/2008 11:39:10 AM

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 60 61

No comments

Sanyo CAS-D6325 User Manual Page 40