Sanyo MM-5600 User Manual Page 31

  • Download
  • Add to my manuals
  • Print
  • Page
    / 330
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 30
Using Your Phone’s Battery and Charger
Battery Capacity
Your Sprint PCS Vision Phone is equipped with a Lithium Ion (LiIon)
battery. It allows you to recharge your battery before it is fully drained.
The battery provides up to 3.4 hours of continuous digital talk time
(up to 1.9 hours in analog).
When the battery reaches 5% of its capacity, the low battery icon
appears. When there are approximately five minutes of talk time left,
the phone sounds an audible alert and then powers down.
Note: Long backlight settings, searching for service, vibrate mode, Sprint PCS
Ready Link mode, and browser use affect the battery’s talk and standby times.
Tip: Be sure to watch your phone’s battery level indicator and charge the battery
before it runs out of power.
Installing the Battery
To install the LiIon battery:
1. Place the battery into the space beneath
the antenna with the metal contacts at
the bottom, facing downward.
2. Gently press down until it’s in place and
the battery release latch snaps.
Removing the Battery
To remove your battery:
1. Make sure the power is off so that you
don’t lose any stored numbers or
messages.
2. Push the battery release latch up and
hold the battery.
3. Pull the battery up and out at a 45-degree
angle.
Section 2A: Your Sprint PCS Vision Phone – The Basics 17
Page view 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 329 330

Comments to this Manuals

No comments