Sanyo LNS-S04 Installation Manual download pdf (Page 5)

-4-

To ensure that the lens is securely fixed to the

projector when mounting, be sure to attach

the Safety Clamp (supplyed with the projector).

There are two different types of Safety Clamps

depending on the lens of the projector.

Please use Safety Clamp of the SC-A type for

this lens.

Fig. 10

1. Remove the screw holding the lens. (See

Fig.9-1)

2. Insert the removed screw to the Safety

Clamp.

3. Place the Safety Clamp in the location of

the removed screw. Make sure that the

Safety Clamp is mounted to hold the Lens

Lock Lever in the lock position. Check the

placement of the Safety Clamp. (See Fig. 9-2)

10

Install the Upper Light-Block Plate into the guide

of Lower Light-Block Plate. (See Fig. 10)

Safety Clamp

(SC-A)

Part No.

(610 322 3742)

Note:

●

When installing the Upper Light-Block Plate,

the Lower Light-Block Plate should be lifted

upward with your hand.

●

Hang the ditch on Lower Light-Block Plate to

the Upper Light-Block Plate.

●

Make sure the mark (UP/DOWN and FRONT/

BACK) on Light-Block Plate is correct and set

them properly.

Fig. 11

Replace and fix the Top Cover with two (2)

Screws A and 2 screws B. (See Fig. 11)

11

9

Upper PlateLower Plate

A

B

A

B

Top Cover

Screw

Lens Lock Lever

Lens Lock Lever

Safety Clamp

Safety Clamp

Attached Figure

Fig. 9-1

Fig. 9-2

Safety Clamp

(SC-A)

Part No.

(610 322 3742)

1 2 3 4 5 6

Comments to this Manuals

No comments