Sanyo MBR-1404GR User Manual download pdf (Page 6)

PRECAUTIONS FOR SAFE OPERATION

Select a level and sturdy floor for installation. This precaution will prevent the unit from tipping.

Improper installation may result in water spillage or injury from the unit tipping over.

Do not install the unit at a place with the possibility of something falling on it. The electric

parts are located in the upper part of this unit.

Connect the unit to a power source as indicated on the rating label attached to the unit. Use

of any other voltage or frequency other than that on the rating label may cause fire or electric shock.

Fix the shelves securely. Incomplete installation may cause injury or damage.

When removing the plug from the power supply outlet, grip the power supply plug, not the cord.

Pulling the cord may result in electric shock or fire by short circuit.

Never damage or break the power supply plug or cord. Do not use the supply plug if its cord

is loose. This may cause fire or electric shock.

Do not touch any electrical parts such as the power supply plug or any switches with a wet hand.

This may cause electric shock.

Do not put a container with water or heavy articles on the unit. Injury may be caused if the

articles fall. Current leakage or electric shock may result from the introduction of spilled water into

electrical components.

Do not climb onto the unit. This may cause damage to the unit and cause it to tip over.

Hold the handle when closing the door. This will reduce the likelihood of a trapped finger.

Do not lean on the door. This may cause injury if the unit tips over.

Never lean or press on the glass. Excessive force may cause injury of the glass breaks.

Check the filter mentioned in this manual and clean it as necessary. A dusty filter may cause

temperature rise or failure.

Do not touch the condenser directly when the filter is removed for cleaning. This may cause injury

due to hot surface.

Disconnect the power supply plug before moving the unit. Take care not to damage the power

cord. A damaged cord may cause electric shock or fire.

CAUTION

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

No comments

Sanyo MBR-1404GR User Manual Page 6