Sanyo SPW-XR254EH56 User Manual download pdf (Page 16)

Fig. 3-4

Shielded wire

Ground

Fig. 3-5

Stranded wire

Ring

pressure

terminal

Strip 10 mm

Fig. 3-6

Wire

Special

washer

Screw

Ring pressure

terminal

Terminal plate

Screw and

Special washer

Ring

pressure

terminal

Wire

(5) Use shielded wires for inter-unit control wiring

wise misoperation from noise may occur.

(Fig. 3-4)

Connect wiring as shown in Section “3-3.

Wiring System Diagrams.”

WARNING

Loose wiring may cause

the terminal to overheat or

result in unit malfunction.

A fire hazard may also

exist. Therefore, ensure

that all wiring is tightly

connected.

When connecting each power wire to the terminal, fol-

low the instructions on “How to connect wiring to the

terminal” and fasten the wire securely with the fixing

screw of the terminal plate.

How to connect wiring to the terminal

■ For stranded wiring

(1) Cut the wire end with cutting pliers, then strip the

insulation to expose the stranded wiring about 10

mm and tightly twist the wire ends. (Fig. 3-5)

(2) Using a Phillips head screwdriver, remove the ter-

minal screw(s) on the terminal plate.

(3) Using a ring connector fastener or pliers, securely

clamp each stripped wire end with a ring pressure

terminal.

(4) Place the ring pressure terminal, and replace and

tighten the removed terminal screw using a screw-

driver. (Fig. 3-6)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Comments to this Manuals

No comments

Sanyo SPW-XR254EH56 User Manual Page 16

Comments to this Manuals

Related products and manuals for Split-system air conditioners Sanyo SPW-XR254EH56