Sanyo SANUPS E11A102A User Manual download pdf (Page 24)

−

9.3 Outage Simulation Test

You should perform a test of whether the UPS operates properly during a power outage.

Proper operation is as described below.

Note

Perform this test before powering the connected load devices on.

Note

If your utility power breaker panel is too far away to access conveniently, you can also perform the

test by setting MAIN SW to the “OFF” and “ON” positions.

Because the UPS continues inverter operation, there is a small amount of voltage (under 30V) at the

input plug. Do not unplug the plug during operation.

①

Set the breaker on your utility power breaker panel to “Off”.

②

Set the breaker on your utility power breaker panel to “On”.

Buzzer

2 beeps..., 2 beeps..., repeated

LEDs

Green INPUT Blinking

Green INV.ON/STAND BY Lit

Green OUTPUT Lit

Buzzer

Silent

LEDs

Green INPUT Lit

Green INV.ON/STAND BY Lit

Green OUTPUT Lit

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 45 46

No comments

Sanyo SANUPS E11A102A User Manual Page 24