Sanyo PDG-DSU30 User Manual download pdf (Page 47)

English

Appendices

Operation

1. Connect the specied RS-232C control cable to SERVICE PORT on

the projector and serial port on the PC.

2. Launch a communication software provided with PC and setup the

communication condition as follows:

3. Type the command for controlling the projector and then enter the

“Enter” key.

Example

When you want to change the input to Computer, Type ‘C’ ‘0’ ‘5’

‘Enter’.

Serial Control Interface

This projector provides a function to control and monitor the

projector’s operations by using the RS-232C serial port.

Baud rate : 9600 bps

Parity check: : none

Stop bit : 1

Flow control : none

Data bit : 8

• The default of the baud rate is set to 9600 bps. If an error occurs in the com-

munication, change the serial port.

• Enter with ASCII 64-byte capital characters and one-byte characters.

ORDER RS-232C CONTROL CABLE

RS-232C control cable can be ordered through your dealer. When order-

ing, give the following information to the dealer.

■ Model No. of your projector : PDG-DSU30

■ RS-232C control cable : Service parts No. CH4200272G002

1 2 ... 42 43 44 45 46 47 48 49 50 51

No comments

Sanyo PDG-DSU30 User Manual Page 47