Sanyo PLC-XU75 Owner's Manual download pdf (Page 12)

Installation

Part Names and Functions

To insure safe operation, please observe the following precautions:

● Use two (2) AA or LR6 type alkaline batteries.

● Always replace batteries in sets.

● Do not use a new battery with a used battery.

● Avoid contact with water or liquid.

● Do not expose the remote control to moisture or heat.

● Do not drop the remote control.

● If the battery has leaked on the remote control, carefully wipe the case clean and install

new batteries.

● Risk of explosion if a battery is replaced by an incorrect type.

● Dispose of used batteries according to the instructions.

Open the battery

compartment lid.

Install new batteries

into the compartment.

Replace the

compartment lid.

Two AA size batteries

For correct polarity

(+ and –), be sure

battery terminals are in

contact with pins in the

compartment.

Remote Control Battery Installation

1 2 3

Point the remote control toward the

projector (Infrared Remote Receiver)

when pressing any button. Maximum

operating range for the remote control is

about 16.4' (5 m) and 60° in front of the

projector.

Operating Range

30°

16.4'

(5 m)

Remote control

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 66 67

No comments

Sanyo PLC-XU75 Owner's Manual Page 12