Sanyo PLC-XU75 Owner's Manual download pdf (Page 45)

Setting

To Enter the Logo PIN code

Select a number by pressing the Point ed buttons.

And then press the Point 8 button to fix the number

and move the pointer. The number changes to "✳".

If you fixed an incorrect number, move the pointer

to the number you want to correct by pressing the

Point 7 button, and then select the correct number

by pressing the Point ed buttons.

Repeat this step to complete entering a four-digit

number.

After entering the four-digit number, move the

pointer to "Set" by pressing the Point 8 button.

Press the SELECT button so that you can change

the Logo PIN code lock setting.

If you entered an incorrect Logo PIN code, "Logo

PIN code" and the number (✳✳✳✳) turns red. Enter

a correct Logo PIN code all over again.

To Change the Logo PIN code

Logo PIN code can be changed to your desired

four-digit number. Select "Logo PIN code change"

with the Point d button and press the SELECT

button. Set a new Logo PIN code.

Be sure to note the new Logo PIN code and keep it

at hand. If you lost the number, you could no longer

change the Logo PIN code setting. For details on

PIN code setting, refer to relevant instructions of the

PIN code lock function on pages 49 and 50.

CAUTION:

WHEN YOU HAVE CHANGED THE LOGO PIN

CODE, WRITE DOWN THE NEW PIN CODE

IN COLUMN OF THE LOGO PIN CODE NO.

MEMO ON PAGE 66, AND KEEP IT SECURELY.

SHOULD THE LOGO PIN CODE BE LOST OR

FO R GO T TE N , TH E PR O JE C TO R CA N NO

LONGER BE OPERATED.

Logo PIN code lock Dialog Box

After a correct Logo PIN code is entered, the

following dialog box appears.

Select On/Off by pressing the Point 7 8

buttons or change the Logo PIN code.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 66 67

No comments

Sanyo PLC-XU75 Owner's Manual Page 45