Sanyo KS1872 User Manual download pdf (Page 15)

Hole in wall

Bent part

Narrow tube

Wide tube

Rear panel

Fig. 38

Drain cap

Drain hose

Fig. 39

I Left-side tubing

(1) Lead the tubing and drain hose through the wall,

allowing sufficient length for connection. Then bend

the tubing using a tube bender to make the attach-

ment. (Fig. 38)

(2) Switch the drain hose and drain cap.

Switching drain hose and drain cap

(a) Locate the drain hose and the drain cap. (Fig.

39)

(b) Remove the screws fastening the drain hose on

the right side, and pull out the drain hose to

remove it. (Fig. 39)

on the left side. (If you cannot pull it off by

hand, use a long-nose pliers.)

(d) Reattach the drain hose to the left side and the

drain cap to the right side. (Fig. 40a)

Drain hose

Slide the drain hose fully onto the drain pan outlet

until the drain hose edge is pushed into the insula-

tion. Check that the screw holes in the drain bracket

and the drain pan outlet are aligned and securely in

contact, then fasten them with the screw. (After

attaching the drain hose, check that it is attached

securely.) (Fig. 40c)

Drain cap

Use a Phillips screwdriver to push the drain cap in

firmly. (If it is difficult to push in, wet the cap with

water first.)

(3) Install the indoor unit on the rear panel.

(4) Connect the tubing and wiring led inside from out-

doors.

(5) After completing a leak test, bundle the tubing

together with armoring tape and store it inside the

tubing storage area at the back of the indoor unit

and hold it with clamps. (Figs. 40a and 41)

Fig. 40a

Fig. 40b

Fig. 40c

Fig. 41

Refrigerant tubing

Inter-unit wiring

Conduit

Screw

Drain hose

Drain pan outlet

Screw hole

Drain bracket

Drain cap

Clamp

Drain hose

Drain bracket

Insulation

05-326 AirCon_85264189988000 12/5/05 3:35 PM Page 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

Comments to this Manuals

No comments

Sanyo KS1872 User Manual Page 15

Comments to this Manuals