Sanyo KS1872 User Manual download pdf (Page 8)

Indoor

side

Outdoor

side

Hole should be made at a slight downward slant to the

outdoor side.

NOTE

Fig. 10

Plastic cover

INSIDE OUTSIDE

Wall

Slight

angle

PVC pipe

(Locally purchased)

Fig. 12

PVC pipe (Locally purchased)

Cut at sli

ht an

Fig. 11

(4) Using a sabre saw, key hole saw or hole-cutting drill

attachment, cut a hole in the wall. See Table 4 and

Fig. 10.

Table 4

(5) Measure the thickness of the wall from the inside

edge to the outside edge and cut PVC pipe at a

slight angle 1/4" (6 mm) shorter than the thickness of

the wall. (Fig. 11)

(6) Place the plastic cover over the end of the pipe (for

indoor side only) and insert the pipe in the wall. (Fig.

12)

3-3. Install the Rear Panel on the Wall

Be sure to confirm that the wall is strong enough to sus-

pend the unit.

See either Item a) or b) below depending on the wall type.

a) If Wooden Wall

(1) Attach the rear panel to the wall with the 8 screws

provided. (Fig. 13)

If you are not able to line up the holes in the rear

panel with the beam locations marked on the wall,

use rawl plugs or toggle bolts to go through the

holes on the panel or drill 3/16" (5 mm) dia. holes in

the panel over the stud locations and then mount the

rear panel.

(2) Double check with a carpenter’s level or tape mea-

sure that the panel is level. This is important to

install the unit properly. (Fig. 14)

(3) Make sure the panel is flush against the wall. Any

space between the wall and unit will cause noise

and vibration.

b) If Block, Brick, Concrete or Similar Type Wall

Make 3/16" (4.8 mm) dia. holes in the wall. Insert rawl

plugs for appropriate mounting screws. (Fig. 15)

Hole Dia.

3-5/32" (80 mm)

Fig. 13

Fig. 14

3/16"

(4.8 mm) dia. hole

Rawl plug

Fig. 15

05-326 AirCon_85264189988000 12/5/05 3:35 PM Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Comments to this Manuals

No comments

Sanyo KS1872 User Manual Page 8

Comments to this Manuals