Sanyo PLV-WF20 Owner's Manual download pdf (Page 83)

Status Read Command

Appendix

The command is sent from PC to the projector with

the format below;

'CR' [Command] 'CR'

Command: one character (refer to the command

table below.

The projector decodes the command and returns the

'Character string' with the format below;

Format

Command Function

Projector

Return

Projector status

CR0 Status Read

Power On

Stand-by mode

Countdown

Cooling down

Power Malfunction

Cooling down at the temperature anomaly

Unable to receive the RC232C command.

Cooling down at Power Management mode

Power Management mode after Cooling down

Cooling down after the projector is turned off when the lamps

are out.

Stand-by mode after Cooling down when the lamps are out.

Stand-by mode after Cooling down at the temperature

anomaly.

Cooling down when the projector is turned off by the shutter

management function.

Stand-by mode after Cooling down by the shutter

management function.

CR6 Temperature Read S1 S2 S3

S1 = Temperature at Sensor 1 (˚C)

S2 = Temperature at Sensor 2 (˚C)

S3 = Temperature at Sensor 3 (˚C)

(ex.) S1 = 12.3˚C, S2 = 23.4˚C, S3 = 34.5˚C

--> The projector displays “12.3 23.4 34.5”

( For each sensor, two digit and the tenth place numbers are

displayed with a space between each temperature.)

Communication failure

The tables on page 82 and 83 show the typical command lists for controlling the projector. Please consult your

local dealer for further information of other commands.

1 2 ... 78 79 80 81 82 83 84

Comments to this Manuals

No comments

Sanyo PLV-WF20 Owner's Manual Page 83

Comments to this Manuals

Related products and manuals for Film projectors Sanyo PLV-WF20