Sanyo Welder MCO-19M(UVH) User Manual download pdf (Page 22)

Using the Unlock Key

Unlocking when power is interrupted

If power is interrupted to the MCO-19M(UVH)/19M(UV) with an MCO-HL installed, the outer door is

electrically locked. To unlock the outer door while the power is interrupted, use the unlock key that is

provided. To lock the outer door again, turn the unlock key to the lock direction while the door is open.

After the door has been locked condition manually, then close the door.

Note:

The outer door cannot be locked by using the unlock key while the door is closed. Lock the door while it is

open. Attempting to turn the unlock key while the door is closed may damage the electric lock system.

WARNING

For the MCO-19M(UVH)/19M(UV) with an MCO-HL installed, the outer door is electrically locked during

decontamination. The chamber is filled with H

gas during decontamination. Do not unlock the door

during decontamination.

CORRECT OPERATION

Use the following procedure to start trial operation or actual operation of the Incubator.

1. Install the Incubator correctly, referring to Installation on page 15.

2. Remove the packing materials from the chamber and inner attachments. Clean and disinfect the

chamber and inner attachments, referring to Routine Maintenance on page 45.

3. Add approximately 1.5 L of sterile distilled water to the humidifying pan. (Refer to page 48.)

4. Turn ON the power supply switch on the left side of the rear panel of the Incubator.

Note:

The humidity in the Incubator chamber is adjusted to the optimum setting. To prevent condensation on

the surface inside chamber and the inner door, there is a low-temperature area under the humidifying pan

in the bottom of chamber to recondense evaporated moisture. Condensation may occur around the

humidifying pan at the bottom of the chamber, but this does not indicate a problem.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 77 78

No comments

Sanyo Welder MCO-19M(UVH) User Manual Page 22