Sanyo CL2472 User Manual download pdf (Page 87)

Care and Cleaning (continued)

Air Clean Filter The air clean filter removes dust and dirt from the air, and reduces odors and

smoke from tobacco.

This air clean filter cannot remove harmful gases or vapors nor ventilate air in

the room. You must open doors or windows frequently when you use gas or oil

heating appliances. Otherwise there is a risk of suffocation in extreme cases.

How to install the air clean

filter

The air clean filter needs to be installed behind the air intake grille.

1. Remove the air intake grille.

2. Install the air clean filter in the

position shown in the figure.

3. Remount the air intake grille.

How to clean the air clean filter • In general, the filter should be sucked to remove dust in low fan speed of a

vacuum cleaner once every three months.

• If there is heavily grime on the filter, soak the filter in lukewarm water with

neutral detergent diluted 1:500 for 1 to 2 minutes then wash it.

• Rinse the filter in clean water, then let it dry on the towel in room temperature.

• Do not bend nor give excessive force onto the air clean filter.

• If the filter surface is heavily blocked with dirt or damaged, replace it with new

one. Purchase a replacement filter at your local dealer. (model STK-FDXB)

Cleaning the main unit and

remote control unit

• Wipe clean using a soft, dry cloth.

• To remove stubborn dirt, moisten a cloth in warm water no hotter than 104 °F,

wring thoroughly, and then wipe.

• The air intake grille can be removed in order to wash it with water.

Removing and remounting the

air intake grille

Refer to “How to remove the anti-mold filter” and “How to replace the anti-mold

filter” on page 22.

When using a footstool or the like, be careful not to let it tip over.

Washing the grille with water • Clean the grille gently using a soft sponge, or the like. Then wipe away any

remaining moisture.

• Neutral detergent may be used to remove stubborn dirt. Then rinse thoroughly

with water and wipe away any remaining moisture.

Cleaning the negative ion

generator

Follow the steps below when the

generator has become dirty.

For safety, be sure to turn the air

conditioner off and also to disconnect

the power before cleaning.

Remove the dust on the negative ion

generator.

• Use a toothbrush, etc. to dust off the end.

• Use a cotton swab, etc., to clean around

the generator inside the plastic case,

taking care not to touch the electrodes.

• During use, the negative ion generator and other metal parts may become

discolored: this is normal and not indicative of malfunctioning.

• If the dirt on and around the negative ion generator is left to build up, a puffing or

sputtering sound will eventually be heard. In this case, clean the generator immediately.

• Do not apply excessive force while performing maintenance.

Air clean

filter

NOTE

CAUTION

Negative ion generator

(metal electrodes inside

plastic case)

NOTE

OI-800-23-EG

01_KS1872_En.fm Page 23 Monday, July 9, 2007 2:54 PM

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 116 117

Comments to this Manuals

No comments

Sanyo CL2472 User Manual Page 87

Comments to this Manuals

Related products and manuals for Conditioners Sanyo CL2472