Sanyo PLCWM5500L Owner's Manual download pdf (Page 59)

Note:

• Factory default is Ready: 5 Min.

• When the shutter is closed while the Power management function

is working, the Power management function is released.

Setting

Select a location of the infrared remote receiver of the remote control.

See “Remote Control Receivers and Operating Range” on page 15 for

details.

All ............ Activate all of the receivers.

Front & Top. . . . . .Activate both the front and top receivers.

Top & Back . . . . . .Activate both the top and back receivers.

Front & Back . . . .Activate both the front and back receivers.

Front ....... Activate only the front receiver.

Top .......... Activate only the top receiver.

Back ........ Activate only the back receiver.

No signal

4 : 50

Timer left before Lamp is off.

Power management

For reducing power consumption as well as maintaining the lamp life,

the Power management function turns off the projection lamp when

the projector is not operated for a certain period.

Select one of the following options:

Ready .................. When the lamp has been fully cooled down, the

POWER indicator changes to green blinking. In

this condition, the projection lamp will be turned

on if the input signal is reconnected or any

button on the side control or remote control is

pressed.

Shut down ........... When the lamp has been fully cooled down, the

power will be turned off.

Off ........................ Power management function is off.

Timer.................... If the input signal is interrupted and no button

is pressed for more than 30 seconds, the timer

display with No signal appears. It starts the

countdown until the lamp is turned off. Use the

Point ▲▼ buttons to set the Timer(1~30Min).

This function is available when operating the projector via network.

Network .......... Supply the power to the network function

even after turning off the projector. You can turn

on/off the projector via network, modify network

environment, and receive an e-mail about projector

status while the projector is powered off.

Eco.................... Select Eco when you do not use the projector

via network. The projector’s network function will

stop when turning off the projector.

Refer to the owner’s manual of “Network Set-up and Operation”.

Note:

• Factory default is Network.

• When selecting Network, the cooling fans may be running depending

on the temperature inside the projector even if the projector is turned off.

• When Eco is selected and the projector is in Stand-by, the communication

of RS-232C serial port is not available.

RC sensor

Power management

Standby mode

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 91 92

Comments to this Manuals

No comments

Sanyo PLCWM5500L Owner's Manual Page 59

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLCWM5500L