Sanyo PLCWM5500L Owner's Manual download pdf (Page 73)

Before calling your dealer or service center for assistance, check the items below once again.

1. Make sure you have properly connected the projector to peripheral equipment as described on pages 19-21.

2. Check the cable connection. Make sure that all computers, video equipment, and power cords are properly connected.

3. Make sure that all power is switched on.

4. If the projector still does not produce an image, restart your computer.

5. If an image still does not appear, disconnect the projector from your computer and check your computer monitor’s display.

A problem may be noticed with your graphics controller rather than with the projector. (When you reconnect the projector,

be sure to turn the computer and monitor off before you turn on the projector. Turn on equipment in the order of the

projector and computer.)

6. If a problem still persists, check the following solutions.

Appendix

Problem: Solutions

No power.

– Plug the power cord of the projector into the AC outlet.

–

Wait until the POWER indicator stops blinking to turn on the projector again. (See

page 23)

–

Check the WARNING TEMP. indicator. If the WARNING TEMP. indicator is blinking,

the projector cannot be turned on. (See page 72)

–

Unlock the Key lock function for the projector. (See page 61)

–

See if the filter cartridge is inserted. (See page 67)

– Check the projection lamp. (See page 70)

PIN code dialog box

appears at start-up.

– PIN code lock is being set. Enter a PIN code; the “1234” or numbers PIN code lock is being set. Enter a PIN code; the “1234” or numbers you have set.

(See pages 23, 61-62)

The initial display is not

shown.

– Make sure Off or Countdown Off is not chosen at Display function.

(See “Setting” section on page 52)

The initial display is not

same with the default one.

– Make sure User or Off is not chosen at Logo select function.

(See “Setting” section on page 52)

When the projector is on

and you press the input

button, an icon other

than the Lamp mode icon

appears.

– That is the Filter warning icon. (See page 66)That is the Filter warning icon. (See page 66)

An icon other than Input

mode or Lamp mode icon

appears.

– That is the Lamp replacement icon or the Filter warning icon. (See pages 66,69)That is the Lamp replacement icon or the Filter warning icon. (See pages 66,69)

No image.

– Check the connection between your computer or video equipment and the projector.

– See if the input signal is correctly output from your computer. Some laptop computers

may need to be changed the setting for monitor output when connected to the

projector. See your computer’s instruction manual for the setting.

– It takes about 30 seconds to display an image after turning on the projector.

– See if the selected system is corresponding with your computer or video equipment.

– Select correct input source once again through menu operation. (See pages 33-35)

– Make sure the temperature is not out of Operating Temperature

(41˚F–104˚F [5˚C–

40˚C]).

appears on the screen

–

End of lamp life is approaching. Replace the lamp with a new one promptly. (See

page 69)

Troubleshooting

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 91 92

Comments to this Manuals

No comments

Sanyo PLCWM5500L Owner's Manual Page 73

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLCWM5500L