Sanyo PLC-EF60A Owner's Manual download pdf (Page 50)

Setting

Logo

Logo settings can be altered as follows:

Logo select

This function decides what to be displayed on the starting-up

display as follows:

Default . . . .the factory-set logo

My logo . . .the image you captured

Off . . . . . . .count-down only

Capture

This function enables you to capture the image being projected

and use it for a starting-up display or interval of presentations.

After capturing the projected image, go to the Logo function and

set it to “My logo.” Then the captured image can be displayed

when turning on the projector next time. (p.27)

To capture the image, select [Yes]. To cancel the Capture

function, select [No].

✔Note:

• Before capturing an image, select Standard in the Image Menu to capture a proper

image. (See page 43.)

• Certain signals may not be captured properly.

• When capturing the image that has been adjusted by the Keystone function, the

adjustment data is automatically reset and the projector captures an image without

keystone correction.

• Once you exit the Logo menu after setting Logo lock to “On,” you are required to

enter the PIN code every attempting to change the Logo setting.

Logo Lock Setting

Lock

This function prevents an unauthorized person from changing the

Logo setting.

Off . . . . .the Logo setting can be changed freely from the

Logo menu.

On . . . . . .the Logo setting cannot be changed without PIN

code.

If you want to change the Logo Lock setting, enter a PIN code

along the following steps. The initial PIN code for Logo Lock

setting is set “4321” at the factory.

Select [Yes]

to capture the

projected

image.

Select [Yes] to

stop capturing.

Capture

Logo Select

Enter a Logo PIN code

Select a number with the Point buttons (e, d, 7, and 8) or the

Control pad and fix the number with the SELECT button. The

number will change to “✳.” If you fixed a wrong number, move

the pointer to “C” with the Point buttons (e, d, 7, and 8) or

the Control pad, then enter the correct number.

Repeat this step to complete entering a four-digit number.

When the four-digit number is fixed, move the pointer to “Ent.”

Press the SELECT button so that you can change the Logo

Lock setting.

If you entered a wrong Logo PIN code, “Logo PIN code” and

the number (✳✳✳✳) will turn red and disappear. Enter a Logo

PIN code all over again.

Enter a Logo PIN code

The input numbers

change to “✳” for

security.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 81 82

Comments to this Manuals

No comments

Sanyo PLC-EF60A Owner's Manual Page 50

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLC-EF60A