Sanyo PLC-EF60A Owner's Manual download pdf (Page 62)

Maintenance and Cleaning

CAUTION :

DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPS IS

REMOVED. IT MAY RESULT IN MALFUNCTIONS, FIRE

HAZARD, OR OTHER ACCIDENTS.

Lamp Replacement

When the life of the projection lamps of this projector draw to an

end, the LAMP 1 and 2 REPLACE indicators light orange. If one of

these indicators lights orange, replace the lamp with a new one

promptly.

Follow these steps to replace the lamp.

Handle

Lamp covers

For continued safety, replace with a lamp of the same

type. Do not drop a lamp or touch a glass bulb! The

glass can shatter and may cause injury.

Allow a projector to cool, for at least 45 minutes before

you open the Lamp cover. The inside of the projector

can become very hot.

Top Control

CAUTION

Screws

(Unremovable)

Turn off the projector and disconnect the AC plug. Allow the

projector to cool for at least 45 minutes.

Loosen two (2) screws of each lamp with a screwdriver and

pull out one lamp and another with grasping the handle.

Replace each lamp with a new one and tighten the two (2)

screws back into the positions. Make sure that the lamp is

set properly. Replace the lamp covers and tighten the

screws.

Loosen each screw on the lamp covers with a screwdriver,

and remove the lamp covers.

Connect the AC power cord to the projector and turn on the

projector.

Reset the Lamp time.

See Lamp on page 57.

Handle

Screws

NOTES ON LAMP REPLACEMENT:

TO MAINTAIN QUALITY OF PICTURE (BETTER BALANCE OF

COLOR AND BRIGHTNESS IN THE ENTIRE SCREEN), WE

RECOMMEND REPLACING ALL 2 LAMPS AT A TIME.

These indicators light orange when the life of the

projection lamps draw to an end.

Lamp 1

LAMP 2 REPLACE

indicator

LAMP 1 REPLACE

indicator

Lamp 2

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 81 82

Comments to this Manuals

No comments

Sanyo PLC-EF60A Owner's Manual Page 62

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLC-EF60A