Sanyo PLC-WTC500AL Owner's Manual download pdf (Page 52)

Picture in Picture

This function is used to project two videos simultaneously

by placing a separate small sub screen within the main

screen.

Use the Point ed buttons to move the red frame

pointer to Picture in Picture and then press the

SELECT button to display a dialog box. Use the Point

7 8 buttons to adjust the setting mode.

✔Note:

•The Picture in Picture function is not available

dependingontheinputsignalsandtheselected

inputterminals.Referto‘ListofPictureinPicture‘

fordetails.(p.82)

•When the input signal(s) is/are incompatible, X

markwillbedisplayedontheMain/Subpicture.

•While the Main and Sub pictures are being

displayed,System,Imageselect,Imageadj.and

Screen menus  (except for ‘Keystone’, ‘Ceiling’

and‘Rear’)areinoperative.

•Only the sound on the Main picture is heard,

the sound on the Sub picture cannot be heard

(In P in P, the big picture is main picture, and

thesmalloneis Sub picture ; in P byP,theleft

pictureisMainpicture,andtherightoneisSub

picture.)

Setting

Mode ............Off

P in P: Provide the images of Sub picture

piling up to Main picture.

P by P: Provide the images of Main picture

and Sub picture side by side at the

same size.

Sub picture.... Size: Select the display size. (Middle/ Large/

Small)

Position: Select the Subpicture position.

(right bottom end/ right top end/

left top end/ left bottom end )

Select the Subpicture input at the Picture in Picture

or Picture by Picture mode :

Press the SELECT button, Sub picture is selected and the

Subpicture frame is indicated in red. Press the intended

INPUT button within 4 seconds and Input of Sub picture is

switched. Press the SELECT button again and Main display

is selected. Red frame of Sub picture will disappear. Press

the intended INPUT button and Input of Main picture is

switched when Main picture is selected.

Background

The selected background screen will be displayed when no

input signal is detected.

Blue ....... Project a blue background

User ....... Project an image selected in the Logo setting.

Black ...... Project a black background

✔Note:

•Whennocapturedimageisset,the“User”optionsisnot

available.

Button operation at the PIP mode on the remote

control and top control :

e : Replace the Main picture and Sub picture.

d : Change the Subpicture size.

7 : Change the Subpicture position

(counterclockwise)

8: Change the Subpicture position

(clockwise)

SELECT : Select the Sub picture or Main picture.

In Picture in Picture mode, press the SELECT button to

select the sub picture and Point ed7 8buttons operate

as follows.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 88 89

Comments to this Manuals

No comments

Sanyo PLC-WTC500AL Owner's Manual Page 52

Comments to this Manuals

Related products and manuals for Film projectors Sanyo PLC-WTC500AL